Watchdog restoring a crashed pi

Support for the UPS PIco HV3.0A, UPS PIco HV3.0 A Plus, UPS PIco HV3.0A Terminal Block products, sd also for updated hardware HV3.0B

Watchdog restoring a crashed pi

Postby lpc » Thu Nov 02, 2017 10:35 am


I have a pico that's on version 0x38. It has the gold pin attached. It is doing well for UPS backup and RTC. However, when the pi crashes I would like the pico to detect this with its watchdog and then power cycle the pi to restart it. I don't see this happening when I successfully force a crash of the pi using instructions on this page.

There are intructions at the bottom of the following thread to edit to make the watchdog do this, but this is outdated, I assume, as if I am correct has been replaced by /usr/local/bin/picofssd?

Do I need some up to date instructions, or would you expect a crash on the pi to result in the pi restarting, without any additions to the normal install of firmware and the pi service? If so would you have some ideas why it isn't working for me? Thanks.
Posts: 9
Joined: Tue Feb 28, 2017 6:09 pm

Re: Watchdog restoring a crashed pi

Postby Pimaster » Thu Nov 23, 2017 10:41 pm

You have been answered on this on ModMyPi forum :-)
Warmest Regards
Designing with Mentor Graphics PADS -
Please read and follow the PiForum rules
Site Admin
Posts: 1618
Joined: Fri Sep 14, 2012 7:50 am

Return to UPS PIco HV3.0A and HV3.0B

Who is online

Users browsing this forum: No registered users and 1 guest