Upgrading UPS Pico firmware resulted in defective I2C

Support for the Uninterruptible Power Supply
with Peripherals and I2C control Interface
Raspberry Pi® B+, A+, B, and A

Upgrading UPS Pico firmware resulted in defective I2C

Postby hugocoolens » Mon Sep 26, 2016 8:42 pm

After installing the software for the UPS Pico on my rpi3 and having working everything fine, I decided to perform the firmware upgrade as is advised in the installation procedure.
After doing that I ended with a rpi3 with a defective i2c-bus, unable to communicate any longer over i2c. The only thing I could do was using another (new) rpi3 and of course this time I
did not perform the firmware upgrade. So be warned!

regards,
Hugo Coolens
hugocoolens
 
Posts: 2
Joined: Mon Sep 19, 2016 6:21 pm

Re: Upgrading UPS Pico firmware resulted in defective I2C

Postby Pimaster » Mon Oct 10, 2016 4:33 pm

HI, We are doing that here hundred of times without problem. You probably made a wrong firmware update, please try it again using hand invoked bootloader as also having free rs232 on the PI3.
BR PiM
Warmest Regards
PiM
---
Designing with Mentor Graphics PADS - www.pads.com
Please read and follow the PiForum rules
http://www.forum.pimodules.com/viewtopic.php?f=13&t=196
---
Pimaster
Site Admin
 
Posts: 1618
Joined: Fri Sep 14, 2012 7:50 am


Return to UPS PIco

Who is online

Users browsing this forum: No registered users and 5 guests

cron